Can't seem to generate requested frequency

[retrorepair]

I've altered the example ino to specifically output 4.43548375mhz by changing:

Si5351.set_freq(443361877ULL, SI5351_CLK0);

Is that not going to work for some reason? I can't seem to find documentation on this

[retrorepair]

Should the serial monitor show anything other than 0 for all registers? Even with the default unedited ino I get this

[retrorepair]

I corrected the frequency to 4433618750ULL but still not working

[la3pna]

What device are you running on? How is the I2C connected? does it have propper bias resistors? With a SI5351 or one of the clones? lør. 9. nov. 2024 kl. 14:07 skrev retrorepair ***@***.***>:

…

I corrected the frequency to 4433618750ULL but still not working — Reply to this email directly, view it on GitHub <#101 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ABBYNPA4WUPVQCFU4MSHPY3Z7YCJXAVCNFSM6AAAAABRLQGNOCVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDINRWGIYDQNJSGU> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>

-- With Best regards, Thomas S. Knutsen. Please avoid sending me Word or PowerPoint attachments.

[la3pna]

Frequencies are given in 0.01Hz as the input. Your input will give 44.336MHz output. https://github.com/etherkit/Si5351Arduino lør. 9. nov. 2024 kl. 14:07 skrev retrorepair ***@***.***>:

…

I corrected the frequency to 4433618750ULL but still not working — Reply to this email directly, view it on GitHub <#101 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ABBYNPA4WUPVQCFU4MSHPY3Z7YCJXAVCNFSM6AAAAABRLQGNOCVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDINRWGIYDQNJSGU> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>

-- With Best regards, Thomas S. Knutsen. Please avoid sending me Word or PowerPoint attachments.

[retrorepair]

Everything is set up fine and the board is a nano. The adafruit library works but I can't deal with the method they use to generate a frequency which I assume is closer to the register setup than the etherkit library